Getting Low-E Glass Preheating Right (Especially When It’s Wide) If you’re working with wide-format Low-E glass, you know the struggle....

Getting Glass Annealing Right with IR If you’ve ever had a piece of lab glassware spontaneously shatter under a vacuum, you know exactly why...

Getting Your Voltage Right with Twin Tube IR Heating Twin tube infrared lamps are a clever bit of engineering. By packing two heating elements into...

Getting Your IR Lamps to Actually Work With Your Glass Here is the problem with standard infrared lamps: they’re often just shouting into the void....

Stop Replacing Your Infrared Heaters Every Six Months If you’ve ever run a shop floor, you know the drill. You install a heater, everything works...

Getting Your SWIR Heating Tubes to Actually Fit Short wave infrared (SWIR) tubes are great for when you need a massive punch of heat, fast. But...

More Than Just a Warm Bathroom Most people think of a bathroom heat lamp as a way to keep from shivering while they get dressed. But we see it...

On the tempering line, the forehearth is where the whole run lives or dies. If you get a cold streak, a slow drift, or uneven heat across the ribbon,...

On a bending line, uneven heat doesn’t hide. You see it immediately—optical distortion, edge waves, thermal stress cracks that show up right at...

On the tempering line, the gob hits the furnace at full speed. If the preheat profile wanders even a little, the glass drags thermal stress right...

On the floor, heat is the lever that sets geometry and stress. When the heating profile drifts, you get bow, warp, or fractures—especially on low-e...

Out on the floor, a cracked lab glass part, a bending mold that’s off, or a delaminated automotive visor doesn’t care about batch cycles. It needs...